Other products / Other products
SaniForce 3150 BES
Specification
| Saniforce 3150 BES Bin Pump BES3XX, BES4XX, 和 BES8XX |
|
| Maximum working fluid pressure | 120 psi ( 8.4 bar, 0.84 MPa ) |
| Compressed air requirement | 80 ~ 120 psi ( 5.5 ~ 8.4 bar, 0.55 ~ 0.84 MPa ) |
| Fluid displacement ( each pump ) | 1.03 gal / cycle ( 3.9 liter / cycle ) |
| Flow rate at 60 cpm | 120 gpm ( 454 lpm ) |
| Pressure ratio | 1:1 |
| Air consumption ( each pump ) | 0.8 scfm per gpm at 70 psi ( 0.006 m3/ minute per lpm at 4.8 bar, 0.48 MPa ) |
| Pump outlet | 3” tri-clamp |
| Sound data | |
| Wetted Parts | 300 series stainless steel, buna-N, and EPDM on the ram plate and seals. |
| Pneumatic Control panel. Maximum input air pressure | 120 psi ( 8.4 bar, 0.84 MPa ) |
| Pneumatic Control panel. Maximum up / down ram pressure | 75 psi ( 5.2 bar, 0.5 MPa ) |
| Pneumatic Control panel. Air inlet – Air controls | 3/4” npt (f) |
| Pneumatic Control panel. Air inlet - pump | 1/2” npt (f) |
| Electronic Control Panel. Maximum input air pressure | 120 psi ( 8.4 bar, 0.84 MPa ) |
| Electronic Control Panel. Maximum up/ down ram pressure | 100 psi ( 7 bar, 0.7 MPa ) |
| Electronic Control Panel. External power supply | 110 VA, 60 Hz, 15 amp maximum circuit breaker required. |
SaniForce 3150 BES:
| P/N | Type | Bin Manuf. | Control Type | Outlet Size | Diaphragm / Ball Material |
| BES3P3 | Ball | Plywood | Manual | 3 inch | Santoprene / PTFE |
| BES3P1 | Ball | Plywood | Electronic | 3 inch | Santoprene / PTFE |
| BES4P3 | Flapper | Plywood | Manual | 3 inch | Santoprene / NA |
| BES8P3 | Ball | Pallecon | Manual | 3 inch | Overmolded EPDM |
| BES3A1 | Ball | Arena | Electronic | 3 inch | Santoprene / PTFE |
| BES4A1 | Flapper | Arena | Electronic | 3 inch | Santoprene / NA |
| BES3F3 | Ball | Tetrapak | Manual | 3 inch | Overmolded EPDM/ PTFE |
Dimensions
